The dual stereo channel S2-CS has two balanced stereo inputs on Neutrik XLR connectors. The INP 1/INP 2 button selects which input is routed through the channel. The button illuminates red to indicate when input 2 is selected. Button operation is inhibited when the channel is "live".nnThere are separate remote logic output controls for the two inputs providing fader or ON button start/stop functions. Remote controls, etc., are triggered when the fader is raised and the channel ON button is green. The start function can be configured to be either momentary (500mS) or latching for each input. The remote outputs on the 9-pin D-type socket are driven by NPN opto-isolators.nnContinuous momentary start can be enabled so that when the fader is raised and the channel is on, each press of the ON button triggers a momentary start. Two remote pins can also be configured for general use as inputs, outputs, latching or momentary and active high or low. Uses include active channel indication or remote control of specific channel functions.nnThe BAL/PAN control adjusts the stereo balance as follows: Fully counter-clockwise moves the signal to the left and boosts the signal by 6dB (right channel decreases by 6dB); fully clockwise moves the signal to the right and boosts the signal by 6dB (left channel decreases by 6dB).nnThe 100mm VCA fader provides unity gain when fully open. The channel input signal is routed to the outputs whenever the fader is open, the ON button is selected, and one or both routing buttons are selected.nnnS2-CSE ChannelnnThe S2-CSE channel is the dual stereo line channel as above but equipped with equalisation, offering 10dB of cut and boost at HF (6.5kHz) and LF (100Hz). The EQ button switches the equalisation in and out of the signal path. The button illuminates yellow when EQ is active. The channel can be used to control one of two timer displays.