Symetrix - xOut 12
Symetrix 80-0090-B - xOut 12
2,669.88 CHF Inc. VAT
-
Delivery
- Shipped in 2 to 3 weeks
-
In-store pickup
- Available in 2 to 3 weeks
Expand Analogue I/O Using Dante. For use with Symetrix Radius, Prism and Edge DSPs, the Symetrix Dante I/O Expanders use Composer for setup. Using Composer eliminates switches, circuit board jumpers, and mechanical adjustments as well as the need for third party software applications.
Features
- Built-in network switches. Direct connections to Radius, Prism and Edge DSP's.
- Internal power supplies.
- xOut 12 – 12 analogue mic/line outputs.
- Designed for Use with Symetrix Dante-enabled DSPs
- Software Setup Using Composer
- Low Cost Way to Increase System Analogue I/O Capacity
- Ultra Low Latency – No Audible Delays
- Top of the Line Specifications
|
|
Specifications |
|
|
General |
|
|
|
Sampling rate |
48 kHz, ± 100 ppm. |
|
|
Frequency response (D/A) |
20 Hz – 20 kHz, ± 0.5 dB. |
|
|
Channel separation (D/A) |
> 111 dB @ 1 kHz, +24 dBu. |
|
|
Dante cable |
Standard CAT6, maximum device to device length = 100 metres. |
|
|
Connectors |
3.81 mm terminal blocks. |
|
|
Number of outputs |
Twelve (12) balanced line level. |
|
|
Nominal output level |
+4 dBu with 20 dB of headroom. |
|
|
Maximum output level |
+24 dBu (+22.8 dBu into a 2k Ohm minimum load). |
|
|
Output Impedance |
300 Ohms balanced, 150 Ohms unbalanced. |
|
|
Dynamic Range |
> 118 dB, A-weighted. |
|
|
THD+Noise |
< -105 dB, unweighted; 1 kHz @ +22 dBu with 0 dB gain. |
|
|
Latency |
0.60 mS |
|
|
Mechanical |
|
|
|
Space Required |
1U (WDH: 18.91 in x 9.5 in x 1.72 in / 48.02 cm x 24.13 cm x 4.37 cm). Depth does not include connector allowance. Allow at least 3 inch additional clearance for rear panel connections. Additional depth may be required depending upon your specific wiring and connections. |
|
|
Electrical |
100-240 VAC, 50/60 Hz, 25 Watts maximum universal input. No line voltage switching required. |
|
|
Ventilation |
Maximum recommended ambient operating temperature is 30 C / 86 F. Ensure that the left and right equipment sides are unobstructed (5.08 cm, 2 in. minimum clearance). The ventilation should not be impeded by covering the ventilation openings with items such as newspapers, tablecloths, curtains, etc. |
